Kawasaki Ninja EX400 Clip Ons with 1-1/2 inch Risers 2018/Current (Race Only Set Up)
The Ninja 400 clip-ons feature a 1 1/2″ riser that eliminates interference issues with the bodywork and fuel tank, while getting the bars as low as possible.
Woodcraft is proud to present our Ninja 400 Clip Ons . We worked hard to develop a set of clip-ons to fit this bike perfectly. A simple re-positioning of the brake line is necessary on this model. The instructions, including a photo, require no cutting or permanent removal of parts. The Ninja 400 clip-ons feature a 1 1/2″ riser that eliminates interference issues with the bodywork and fuel tank, while getting the bars as low as possible.
Woodcraft Ninja 400 Clip Ons 2-piece split clip ons are specially designed to make installation and removal a snap. Our 2-piece design is race proven and makes it easy to service your clip ons below the triple clamp without having to disassemble the entire front end.
Special attention has also been taken to save weight wherever possible on these clamps. The bars themselves are 12” long and are easily adjusted to whatever custom width you desire. Racers no longer have to worry about replacing an expensive complete clipon assembly after a crash – these risers use an inexpensive universal handlebar. *Comes with Bars*
These clip ons are being used by racers at all levels round the world from BSB Junior cup series to Moto America here in the USA
These clip ons are the same ones we use to build the Spears Racing 400 Ninja’s
IMPORTANT NOTE: The front brakes must be bled after the brake line has been re-positioned to ensure that there is no air in the brake line